Keurig 60 200258 037 User Manual

b06739_QuickStartInsert_B60 5/2/05 4:57 PM Page 1  
®
KEURIG  
Quick Start Guide  
Premiuum Coffffee Sysstems  
Let the Magic Begin FAST!  
®
Thank you for purchasing a Keurig Special Edition - Model B60 Gourmet Single  
Cup Home Brewing System.  
IMPORTANT: You cannot use your Keurig Brewer until it has been primed for its first  
use as set forth below. Please follow these easy steps and you will discover what  
Deliciously Simpletruly means.  
Please note, if your Brewer has been exposed to temperatures below freezing, it is recommended you  
allow two hours for an unpacked brewer to warm to room temperature before priming or brewing.  
displayed and the Travel Mug button will flash.  
1. Unpacking the Special Edition -  
g. Press the blue Travel Mug button to start a cleans-  
Model B60 Brewer  
ing brew, during which hot water will flow into your  
a. Carefully remove the Brewer by placing the box on  
cup or mug. Pour the hot water into the sink.  
its side, and pulling the Brewer out of the box and  
h. The one-time priming process is now complete and  
you are ready to brew!  
removing the protective materials.  
b. Place the Brewer upright on a flat surface. Remove  
three pieces of adhesive tape from Brewer.  
NOTE: The Brewer may take 15 seconds to reheat  
between brews and the LCD Control Center will  
indicate 'NOT READY'. During this time the pump  
may cause a vibration noise. This is normal. The  
LCD Control Center will indicate 'READY TO BREW'  
once the water has heated and the Brewer is ready.  
c. Unwrap cord and plug Brewer into a grounded outlet.  
2. Priming  
a. Place a cup or mug on the Drip Tray Plate.  
b. Remove the Water Reservoir from the Brewer by  
first removing the Lid from the Water Reservoir,  
then lifting the Water Reservoir straight up and away  
from the Brewer. Rinse and fill with cold water.  
Replace the Water Reservoir back on the Brewer  
and replace the Lid.  
3. Choose  
a. Place a cup or mug on the Drip Tray Plate.  
b. Select a K-Cup® portion pack.  
Do not remove the foil lid.  
c. Press the Power Button to turn the Brewer on and  
the blue light in the Water Reservoir and LCD  
Control Center will become illuminated.  
4. Brew  
a. Lift the Handle, place the K-Cup in the K-Cup Holder  
Assembly and then push the Handle all the way  
down to puncture the K-Cup.  
d. The LCD Control Center will indicate ‘PRIME’ and  
the Travel Mug button will flash. Please note, a  
K-Cup® portion pack should not be used for the  
Priming Sequence.  
Please be careful to avoid the sharp needles in the  
K-Cup Assembly Housing & Lid.  
Power Button  
b. Select a brew size by pressing the flashing Cup,  
Mug or Travel Mug button.  
PRIME  
READY  
TO BREW  
Travel Mug  
Button  
Travel Mug  
Button  
MENU  
Cup Button  
e. Press the flashing blue Travel Mug button.  
Mug Button  
f. The Brewer will automatically fill (priming it) and then  
the water will be heated. This will take about 3 minutes.  
During the heating period the ‘NOT READY’ indicator  
will be on. When the water is heated ‘READY’ will be  
NOTE: The smaller cup will brew stronger tasting  
coffee/tea.  
Please consult the Use & Care Guide for additional information on your Brewer. If you  
are experiencing problems, contact Customer Service at 1-866-901-BREW (2739).  
© 2005 Keurig Incorporated  
Part #: 60-200258-037  
Revision A, April 2005  

Keurig Vue Brewer V700 User Manual
Kenwood KDC X990 User Manual
JVC KD G801 User Manual
HTC Touch Pro RAPH800 User Manual
HTC Desire Desire User Manual
HP Hewlett Packard 5992 3193 User Manual
Hauppauge Computer Works Computer Drive WinTV HVR 950 User Manual
Grindmaster 8306 User Manual
Emerson 680 3516 CKS3516 User Manual
Ayre Acoustics CX 7EMP User Manual